Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2013 >> Genesis 3.8 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (Engine Control System - 5.0L) >> ETC (Electronic Throttle Control) System >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
  2. Remove the resonator and the air intake hose (Refer to "INTAKE MANIFOLD " in EM group).
  3. Disconnect the ETC module connector (A).
  4. Remove the installation bolts (B), and then remove the ETC module (C) from the engine.
    Fig 1: Identifying ETC Module, Connector And Installation Bolts
    G08822850Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About Mike's Workshop Manuals