Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2013 >> Elantra GT Automatic Trans >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System Diagnosis (2 Of 2) >> DTC P1566: Analog Battery Sensor Circuit >> Scantool Diagnostics >> Monitor DTC Status

Monitor DTC Status

  1. Connect scantool to Data Link Connector (DLC).
  2. IG "ON".
  3. Select "DTC" button, and then Press "DTC Status" to check DTC's information from the DTCs menu.
  4. Read "DTC Status" parameter.
  5. Is parameter displayed "Present fault"?

    YES 

    NO 

    • Fault is intermittent caused by poor contact in the sensor's and/or ECM's connector or was repaired and ECM memory was not cleared. Thoroughly check connectors for looseness, poor connection, ending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
scientia non olet · About Mike's Workshop Manuals