Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2012 >> Veloster Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 21 (Engine Control System - Turbo) >> CVVT Oil Control Valve (OCV) >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different car, the 2014 Hyundai Veloster and 2013 Hyundai Veloster. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
  2. Disconnect the CVVT oil control valve connector (A).
  3. Remove the installation bolt (B), and then remove the valve from the engine.

    [Bank 1/Intake] 

    Fig 1: CVVT Connector & Bolt (Bank 1/Intake)
    G09151131Courtesy of HYUNDAI MOTOR AMERICA

    [Bank 1/Exhaust] 

    Fig 2: CVVT Connector & Bolt (Bank 1/Exhaust)
    G09151132Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About Mike's Workshop Manuals