Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2012 >> Veloster Standard Trans >> Repair and Diagnosis >> Accessories & Equipment >> Cruise Control Systems >> Cruise Control Switch >> Repair Procedures >> Inspection >> Measuring Resistance

Measuring Resistance

  1. Disconnect the cruise control switch connector from the control switch.
    Fig 1: Disconnecting Cruise Control Switch Connector From Control Switch
    G08806935Courtesy of HYUNDAI MOTOR AMERICA
  2. Measure resistance between terminals on the control switch when each function switch is ON (switch is depressed).
    Function switch Terminal Resistance
    CANCEL 3 - 4 180Ω ± 5%
    SET/- 3 - 4 330Ω ± 5%
    RES/+ 3 - 4 550Ω ± 5%
    ON/OFF 3 - 4 880Ω ± 5%
  3. If not within specification, replace switch.
scientia non olet · About Mike's Workshop Manuals