Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2012 >> Veloster Automatic DCT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 21 (Engine Control System - Turbo) >> RCV Control Solenoid Valve >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different car, the 2014 Hyundai Veloster and 2013 Hyundai Veloster. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
  2. Remove the air duck (A).
    Fig 1: Air Duct
    G09151140Courtesy of HYUNDAI MOTOR AMERICA
  3. Disconnect the cooling pan control connector (A) and cooling pan & RCV extension connector (B) from the bracket.
    Fig 2: Cooling Pan Control & Recirculation Valve Extension Connectors
    G09151141Courtesy of HYUNDAI MOTOR AMERICA
  4. Disconnect the RCV control solenoid valve connector (A) and vapor hose (B).
  5. Remove the installation bolts (C) and then RCV control solenoid valve (D).
    Fig 3: RCV Control Solenoid Valve, Connector & Vapor Hose
    G09151142Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About Mike's Workshop Manuals