Monitor Scantool data

Check DTC
1. Check DTC with scantool.
2. Check DTC related CAN communication is set on Smart Key Module and every modules.
3. If there is DTC related Module Check the DTC according to troubleshooting guide.
4. Repair and erase the DTC with Scantool.
5. Is the DTC erased?
  YES
  - Check poor connection between harness connector and Smartkey Module or ECM
    : Thoroughly check the looseness, poor connection, bent, corrosion, contamination, deformation or damage of connector. Repair or replace as necessary and then, go to "VERIFICATION OF VEHICLE REPAIR " procedure.
  NO
  - Go to next procedure.