Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2012 >> Sonata GLS, Automatic Trans >> Repair and Diagnosis >> Body & Frame >> Ignition Switch/Steering Lock >> Ignition Switch Assembly (Except HEV) >> Repair Procedures >> Removal

Repair Procedures: Removal

  1. Disconnect the negative (-) battery terminal.
  2. Remove the driver crash pad lower panel.

    (Refer to the "CRASH PAD ")

  3. Remove the steering column upper and lower shrouds.

    (Refer to the "CRASH PAD ")

  4. Remove the wiper switch.

    (Refer to the WINDSHIELD WIPER-WASHER SWITCH )

  5. Remove the ignition switch after disconnecting the ignition switch 6P connector (A)
    Fig 1: Identifying Ignition Switch 6P Connector
    G07364798Courtesy of HYUNDAI MOTOR CO.
  6. Remove the key warning/immobilizer connector (A).
    Fig 2: Identifying Key Warning/Immobilizer Connector
    G07364799Courtesy of HYUNDAI MOTOR CO.
  7. After loosening the screw, remove the key warning switch and key Illumination (A).
    Fig 3: Identifying Key Illumination
    G07364800Courtesy of HYUNDAI MOTOR CO.
  8. Pushing lock pin with key ACC.
    Fig 4: Locating Lock Pin
    G07364801Courtesy of HYUNDAI MOTOR CO.
  9. Remove the key lock cylinder (A).
    Fig 5: Removing Key Lock Cylinder
    G07364802Courtesy of HYUNDAI MOTOR CO.
scientia non olet · About Mike's Workshop Manuals