Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2012 >> Genesis Coupe 2.0T, Automatic Trans >> Repair and Diagnosis >> Brakes >> Traction Control >> Electronic Stability Control (ESC) System >> Rear Wheel Speed Sensor >> Repair Procedures >> Removal

Repair Procedures: Removal

  1. Remove the rear wheel speed sensor mounting bolt (A).

    Tightening torque:  6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft)

    Fig 1: Identifying Rear Wheel Speed Sensor Mounting Bolt
    G06509989Courtesy of HYUNDAI MOTOR CO.
  2. Remove the rear wheel guard.
  3. Disconnect the rear wheel speed sensor connector (A). And remove the rear wheel speed sensor.
  4. Installation is the reverse of removal.
scientia non olet · About Mike's Workshop Manuals