Verification of Vehicle Repair

After a repair, it is essential to verify that the fault has been corrected.

1. Connect scantool and select "Diagnostic Trouble Codes (DTCs)" mode.
2. Using the scantool, clear DTC.
3. Operate the vehicle within the "Enable Conditions" shown in DTC DETECTING CONDITION CHART. (Start and drive vehicle in gear and maintain vehicle speed at or above 10kmh. (6.2mph))
4. Using the scantool, check if any DTC's are present.
5. Are any DTCs present?

   YES 

   • Go to the appropriate troubleshooting procedure.

   NO 

   • System performing to specification at this time.