Monitor Scantool Data

Check DTC
1. Check DTC with GDS.
2. Check if DTC related to CAN communication is set on PDM.
3. If there is a DTC related to PDM, check the DTC according to Troubleshooting .
4. Repair and erase the DTC with GDS.
5. Is the DTC erased?
  YES
  - Check for poor connection between harness connector and each module
    Thoroughly check connector for looseness, poor connection, bending, corrosion, contamination, deformation, or damage. Repair or replace as necessary, and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
  NO
  - Go to next procedure.