General Information: DTC Detecting Condition

WARNING: This page is about a different variant/trim than selected.

Item	Detecting Condition	Possible Cause
DTC Strategy	Signal Voltage Check	Short to battery/ground, open or poor contact on Drive Motor circuit Short to battery/ground, open or poor contact on Hall IC Sensor circuit Faulty Drive Motor and the related components Faulty Hall IC Sensor Blown fuse Faulty PTM (These troubles may lead the counter direction movement of the trunk lid)
Enable Conditions	IG ON In case of faulty Drive Motor When the trunk is opening or closing by mechanical power (By pushing the local switch) In case of faulty Hall IC Sensor When the trunk is opening or closing by the hand operated working
Threshold Value	Faulty Drive Motor The fixed signal due to no motor working Faulty Hall IC Sensor The fixed signal (The steady voltage between 5 V and 10 V)
Diagnostic Time	3 times in sequential (Present DTC)
DTC Erasing Time	Erase the present DTC in the moment of Wake-up after Sleep or trouble fixed. (The present DTC → The past DTC)
Limp Home Mode	It is available to operate by hand-operated (Except motor stuck)