Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2012 >> Elantra Touring GLS, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 9 (Supplemental Restraint System Control Module (SRSCM) & Sensors) >> SRS Control Module (SRSCM) >> Repair procedures >> Removal

Repair procedures: Removal

WARNING: This page is about a different car, the 2011 Hyundai Accent. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative (-) cable from battery and wait for at least three minutes.
  2. Remove ignition key from the vehicle.
  3. Disconnect the DAB, PAB, SAB, CAB and BPT connectors.
  4. Remove the floor console. (Refer to CONSOLE )
  5. Press the lock (1), then pull back the connector lever (2) until it clicks.
    Fig 1: Pulling Back Connector Lever
    G06879914Courtesy of HYUNDAI MOTOR CO.
  6. Disconnect the SRSCM harness connector (A) and (B) from the SRSCM.
  7. Remove the SRSCM mounting bolts (3EA) from the SRSCM, then remove the SRSCM.
    Fig 2: Locating SRSCM Mounting Bolts
    G06879915Courtesy of HYUNDAI MOTOR CO.
scientia non olet · About Mike's Workshop Manuals