Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2012 >> Elantra Touring GLS, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 9 (Supplemental Restraint System Control Module (SRSCM) & Sensors) >> SRS Control Module (SRSCM) >> Repair procedures >> Installation

Repair procedures: Installation

WARNING: This page is about a different car, the 2011 Hyundai Accent. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative (-) cable from battery and wait for at least three minutes.
  2. Remove ignition key from the vehicle.
  3. Install the SRSCM with the SRSCM mounting bolts.

    Tightening Torque (SRSCM Mounting Bolt) 

    : 1.0 ~ 1.4 kgf.m (9.5 ~ 13.6 Nm, 7.0 ~ 10.0 lb.ft)

    NOTE: Use new mounting bolts when replacing the SRSCM after a collision.
  4. Connect the SRSCM harness connector.
    Fig 1: Connecting SRSCM Harness Connector
    G06879916Courtesy of HYUNDAI MOTOR CO.
  5. Install the floor console. (Refer to CONSOLE )
  6. Connect the DAB, PAB, SAB, CAB and BPT connectors.
  7. Reconnect the battery negative cable.
  8. After installing the SRSCM, confirm proper system operation:
    1. Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
scientia non olet · About Mike's Workshop Manuals