Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2012 >> Elantra GLS, Automatic Trans >> Repair and Diagnosis >> Brakes >> Traction Control >> Antilock Brake System (Abs)/Electronic Stability Control (ESC) System >> DTC C1260: Steering Angle Sensor Circuit-Signal >> General Information >> DTC Detecting Condition

General Information: DTC Detecting Condition

DTC DETECTING CONDITION

Item Detecting Condition Possible cause
DTC Strategy
  • Signal Monitoring
  1. Incorrect calibration
  2. Improper installation of steering angle sensor
  3. Faulty steering angle sensor
Enable Conditions
  • During straight driving, If the steering wheel angle is larger than 55 degree.
  • When the steering wheel angle is larger than ±780 degrees.
  • When the difference between estimated angle and measured angle of the SAS sensor is lager than 50deg/s, if the fault condition exists uninterrupted for 1.5sec.
  • In case that diagnostic signal fault of SAS was happened for more than 100ms within normal voltage condition.
Fail Safe
  • Inhibit the ESC/DBC control and allow the ABS/EBD control.
  • The ESC/DBC warning lamp is activated.
scientia non olet · About Mike's Workshop Manuals