Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2011 >> Santa Fe SE, FWD >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> SRSCM (Supplement Restraint System Control Module) >> Side Impact Sensor (SIS) >> Repair procedures >> Removal >> Front Side Impact Sensor

Front Side Impact Sensor

CAUTION:
  • Removal of the airbag must be performed according to the precautions/procedures described previously.
  • Before disconnecting the side impact sensor connector (s), disconnect the side airbag connector (s).
  • Do not turn the ignition switch ON and do not connect the battery cable while replacing the side impact sensor.
  1. Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
  2. Remove the front door trim. (Refer to FRONT DOOR .)
  3. Disconnect the Side Impact Sensor connector and remove the Side Impact Sensor mounting bolt.
    Fig 1: Identifying Front Side Impact Sensor (FSIS) Location
    G06844356Courtesy of HYUNDAI MOTOR CO.
scientia non olet · About Mike's Workshop Manuals