Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2011 >> Genesis 3.8 >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Supplemental Restraint System Control Module >> Troubleshooting for DTC >> DTC B1418: SIS (Side Impact Sensor) Rear-Driver Defect >> Component Inspection

Component Inspection

  1. Ignition "ON" & Engine "OFF" and Using a scan tool, clear the DTC.
  2. Ignition "OFF".
  3. Disconnect the battery (-) terminal cable from the battery, and wait at least one minutes.
  4. Disconnect RDSIS connector.
  5. Substitute the RDSIS and check for proper operation.
  6. is DTC present problem?

    YES 

    • Substitute a known-good SRSCM, and check for proper operation.

      If the problem is corrected, replace SRSCM and then Go to "Verification of Vehicle Repair " procedure.

    • Substitute the SRSCM main harness and check for proper operation.

      If the problem is corrected, replace SRSCM main harness and then Go to "Verification of Vehicle Repair " procedure.

    NO 

    • Substitute a known-good RDSIS, and check for proper operation.

      If the problem is corrected, replace SRSCM and then Go to "VERIFICATION OF VEHICLE REPAIR" procedure.

scientia non olet · About Mike's Workshop Manuals