Repair Procedures: Installation

Front Side Impact Sensor 

1. Install the new Side Impact Sensor with the nut after connecting the SRS harness connector to the Side Impact Sensor.

   Tightening torque 

   : 0.9 ~ 1.2 kgf.m (8.5 ~ 11.5 Nm, 6.3 ~ 8.5 lb.ft)

2. Install the seat belt pretensioner with two mounting bolts.

   Tightening torque 

   : 4.0 ~ 5.5 kgf.m (39.2 ~ 53.9 Nm, 28.9 ~ 39.8 lb.ft)

3. Install the center pillar trim. (Refer to INTERIOR
4. Install the front seat assembly. (Refer to SEAT & POWER SEAT
5. Reconnect the battery negative cable.
6. After installing the Side Impact Sensor, confirm proper system operation: Turn the ignition switch ON, the SRS indicator light should be turned on for about six seconds and then go off.

Rear Side Impact Sensor 

1. Install the new Side Impact Sensor with the bolt then connect the SRS harness connector to the Side Impact Sensor.

   Tightening torque 

   : 0.9 ~ 1.2 kgf.m (8.5 ~ 11.5 Nm, 6.3 ~ 8.5 lb.ft)

2. Install the rear side seatback.

   Tightening torque 

   : 1.7 ~ 2.6 kgf.m (16.7 ~ 25.5 Nm, 12.3 ~ 18.81 lb.ft)

   Fig 1: Locating Rear Side Seatback Bolt

   Courtesy of HYUNDAI MOTOR CO.
3. Install the rear seat cushion. (Refer to REAR SEAT
4. Reconnect the battery negative cable.
5. After installing the Side Impact Sensor, confirm proper system operation: Turn the ignition switch ON, the SRS indicator light should be turned on for about six seconds and then go off.