Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2010 >> Santa Fe GLS, 2.4 B, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Engine Control System - 3.5L) >> VCM Position Sensor >> Repair procedures >> Removal

Repair procedures: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
  2. Remove the intake manifold. (Refer to INTAKE AND EXHAUST SYSTEM .)
  3. Remove the installation screws (A), and then remove the VCM position sensor.
    Fig 1: Locating VCM Position Sensor Screws
    G06844932Courtesy of HYUNDAI MOTOR CO.
scientia non olet · About Mike's Workshop Manuals