Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2010 >> Genesis Coupe 2.0T Track >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> SRS Control Module (SRSCM) >> DTC B1400: SIS (Side Impact Sensor) Front-Driver Defect >> Component Inspection

Component Inspection

  1. With Ignition ON & Engine OFF, clear the DTC using the scan tool.
  2. Ignition "OFF".
  3. Disconnect the battery (-) terminal cable from the battery, and wait at least one minutes.
  4. Disconnect DSIS connector.
  5. Substitute the DSIS and check for proper operation.
  6. Is DTC present?

    YES 

    • Substitute a known-good SRSCM, and check for proper operation.

      If the problem is corrected, replace SRSCM and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    • Substitute the SRSCM main harness and check for proper operation.

      If the problem is corrected, replace SRSCM main harness and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NO 

    • Substitute a known-good DSIS, and check for proper operation.

      If the problem is corrected, replace DSIS and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.

scientia non olet · About Mike's Workshop Manuals