DTC P0905: Gate Select Position Circuit Range/Performance: DTC Detecting Condition

P0905 GATE SELECT POSITION CIRCUIT RANGE/PERFORMANCE

Item	Detecting Condition	Possible Cause
DTC Strategy	Check function	Wiring Inhibitor s/w Mechatronics (E-module + Valvebody)
Enable Conditions	Inhibitor switch : normal Range switch : normal Range position : "D"
Threshold Value	Detected position change in not Sports mode Detected "+, -" signal out of Sports mode
Diagnostic Time	1.06 second
Fail Safe	Normal driving in "D range" (priority: 2)

CAUTION:

The function with the higher priority will always take precedence. However, a low-priority is not overruled by a higher priority function.
Functions from different priority categories can also run in parallel. It is important to note which function will take precedence in this case.
In such an event it is possible for a substitute function with low priority not be carried out if a second, higher-priority function is present. This has been taken into account when compiling the priority list and is international.
The mechanical emergency run function must always have the highest priority, since from the electrical standpoint it is the only safe condition.