Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2010 >> Genesis 4.6 >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transaxle System (6HP26) >> Troubleshooting For DTC >> DTC P0905: Gate Select Position Circuit Range/Performance >> Component Inspection

Component Inspection

  1. Ignition "OFF".
  2. Connect "Sports mode s/w" connector.
  3. Ignition "ON" & Engine "OFF".
  4. Measure the voltage between wiring side of "Sport mode select s/w, Sport mode up s/w, Sport mode down s/w" and chassis ground.
  5. Confirm voltage change when select "+, -".

    Specification:  12V (Before select) -> 0V (After select)

  6. Is "Measured voltage" within specification?

    YES 

    • Fault is intermittent caused by poor contact in the sensor's and/or PCM/TCM's connector or was repaired and PCM/TCM memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration or damage. Repair or replace as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NO 

scientia non olet · About Mike's Workshop Manuals