Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2010 >> Azera GLS >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transaxle Diagnosis >> DTC P0708: Transmission Range Sensor Circuit High Input >> Inspection Repair >> Component Inspection

Component Inspection

  1. Ignition "OFF".
  2. Remove "TRANSAXLE RANGE SWITCH"
  3. Measure the resistance between each terminal of the sensor

    Specification:  Approx. 0 Ω

    Fig 1: Measuring Resistance Between Terminal Of Sensor
    G06806205Courtesy of HYUNDAI MOTOR CO.

    [RANGE SWITCH continuity check table (Case of SPORTS MODE vehicle has no 3,2, L range)] 

    TERMINAL RESISTANCE REFERENCE CHART

    Range Terminal
    P R N D 3 2 L
    1       •      
    2           •  
    3 •            
    4     •        
    5         •   •
    6              
    7   •          
    8 • • • • • • •
    9 •   •        
    10 •   •        
  4. Is resistance within specifications?

    YES 

    • Substitute with a known-good PCM/TCM and check for proper operation. If the problem is corrected, replace PCM/TCM as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NO 

scientia non olet · About Mike's Workshop Manuals