Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2009 >> Veracruz GLS, AWD >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Immobilizer Control System >> DTC P1692 Immobilizer Indicator Lamp Error >> Monitor DTC Status

Monitor DTC Status

  1. Connect scan tool to Data Link Connector (DLC).
  2. IGN "ON" & Engine "OFF"
  3. Select "Diagnostic Trouble Codes (DTCs)"mode and monitor "DTC Status" parameter
  4. Is the DTC P1692 present ?
    NOTE: Right after ignition "ON", Immobilizer lamp lights up for 30sec.
    If lamp blinks 5 times after ignition "ON", there's any fault in immobilizer system.

    YES 

    • Go to "inspection & Repair" procedure

    NO 

    • Fault is intermittent caused by poor contact in SMARTRA's and/or ECM's connector or was repaired and ECM memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
scientia non olet · About Mike's Workshop Manuals