Check the Engine Oil Contamination
- Check the engine oil level. The oil level should be between the min. and max. marking. Fill to the correct oil level.
- Warm up the engine to normal operating temperature.
- Connect Scantool and note the "SHORT TERM FUEL-B1" parameter on the Scantool data list.
- Disconnect and plug the positive crankcase ventilation.
- Monitor the "SHORT TERM FUEL-B1" parameter on the Scantool data list once again.
Specification : The value should remain more or less unchanged.
- Is the displayed value within the specified value?
YES
- Go to "SENSOR CONTAMINATION INSPECTION " procedure.
NO
- The engine oil is diluted with fuel. Change the oil and oil filter and go to "VERIFICATION OF VEHICLE REPAIR " procedure.