PODS Re-zero procedure

You should perform PODS Re-zero procedure after service or replacement about all part of the passenger seat.

1. Ignition "OFF", connect scantool.
2. Ignition "ON" & Engine "OFF", select Airbag system and "PODS Reset" mode.
   Fig 1: Scan Tool Display - Ignition "OFF"

   Courtesy of HYUNDAI MOTOR CO.
   Fig 2: Scan Tool Display - Select Airbag System And "PODS Reset" Mode

   Courtesy of HYUNDAI MOTOR CO.
3. The scantool will show the two PODS RESET function steps.
   1. Erase PODS ECU diagnostic codes.
   2. PODS ECU initialization.
   Fig 3: Scan Tool Display - PODS RESET Function

   Courtesy of HYUNDAI MOTOR CO.
4. Press the OK button to erase the PODS related diagnostic codes.
   Fig 4: Scan Tool Display - Press OK Button

   Courtesy of HYUNDAI MOTOR CO.
5. Press OK button to initialize the PODS.
   Fig 5: Scan Tool Display - Press OK Button

   Courtesy of HYUNDAI MOTOR CO.
   CAUTION: This step must be done PODS re-zero, when the front passenger seat is empty.
6. The PODS initialization procedure will be performed.
   Fig 6: Scan Tool Display - PODS Initialization

   Courtesy of HYUNDAI MOTOR CO.
7. Check PODS situation with selecting " Pass. Airbag Realtime Info" after performing PODS Reset procedure.
   Fig 7: Scan Tool Display - PODS Situation With Selecting " Pass

   Courtesy of HYUNDAI MOTOR CO.
8. Perform inspection with pressing OK button.
   Fig 8: Scan Tool Display - Pressing OK Button

   Courtesy of HYUNDAI MOTOR CO.
9. Finish the procedure with pressing cancel button if there is no problem after inspecting each status as below.
   Fig 9: Scan Tool Display - Passenger Airbag Status (1 Of 3)

   Courtesy of HYUNDAI MOTOR CO.
   Fig 10: Scan Tool Display - Passenger Airbag Status (2 Of 3)

   Courtesy of HYUNDAI MOTOR CO.
   Fig 11: Scan Tool Display - Passenger Airbag Status (3 Of 3)

   Courtesy of HYUNDAI MOTOR CO.