Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2009 >> Genesis 4.6 >> Repair and Diagnosis >> Accessories & Equipment >> Communication Devices >> BCM (Body Control Module) >> Troubleshooting >> B1971 Parking Position Input Error >> Scantool Data Analysis

Scantool Data Analysis

  1. Connect GDS.
  2. IG "ON" and engine "OFF".
  3. Select "DTC Analysis" mode.
  4. After erase DTC, keep the vehicle condition within "the enable conditions" (Refer to "DTC DETECTING CONDITION " table).
    Fig 1: Scan Tool Display - Park Position Error
    G06101333Courtesy of HYUNDAI MOTOR CO.
  5. Is the same DTC occurred again?

    YES 

    • Go to next procedure.

    NO 

    • Fault is intermittent caused by poor contact in the sensor's and/or PSM's connector or was repaired and PSM memory was not cleared. T-horoughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
scientia non olet · About Mike's Workshop Manuals