B1971 Parking Position Input Error: DTC Detecting Condition
B1971 PARKING POSITION INPUT ERROR
| Item |
Detecting Condition |
Possible Cause |
| DTC Strategy |
- Check Stop Switch "ON" by the voltage level (Below 2V)
- Check the vehicle speed signal from CLU (2MPH 3km/h)
- IGN ON
|
- Check Stop Signal Input state (ON/OFF)
|
| Enable Conditions |
- Button Start Vehicle (Option)
- Stop Switch : ON
- In case of no ESCL error
- Vehicle speed : above 2MPH (3km/h)
|
| Threshold Value |
- Stop Signal Input ON : Below 2V
- Stop Signal Input OFF : Above 7V
|
| Diagnostic Time |
- Stop Switch is "ON" for 10sec and above under IG ON I and the vehicle speed is over 2MPH (3km/h).
|
| DTC Erasing Time |
|