Component Inspection

Check rear wiper
1. Ignition "ON" & engine "OFF"
2. Disconnect rear wiper motor.
3. Measure the resistance between rear wiper motor signal circuit connector terminal (R16-3) and ground circuit connector terminal (R16-1).
  Specification : ∞ Ω
  
  Fig 1: Measuring Resistance Between Rear Wiper Motor Signal Circuit Connector Terminal (R16-3) And Ground
  Courtesy of HYUNDAI MOTOR CO.
4. Is the measured resistance within the specification?
  YES
  
  Go to "COMPONENT INSPECTION ".
  
  NO
  
  Repair open in power circuit and Go to "VERIFICATION OF VEHICLE REPAIR ".
Check RAM
1. Connect scantool to Data Link Connector (DLC).
2. Ignition "ON" & engine "OFF"
3. Check if DTC is erased after replacing RAM with "RAM for test".
4. Is the DTC erased?
  YES
  
  Replace "RAM for test" with "new RAM" and go to "VERIFICATION OF VEHICLE REPAIR ".
  
  NO
  
  Check connecting condition of connector and go to "VERIFICATION OF VEHICLE REPAIR ".