Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2009 >> Elantra Touring Standard >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> SRS Control Module (SRSCM) >> Troubleshooting For DTC >> B1324 WCS (Weight Classification System) Communication Error >> Communication K LINE Inspection

Communication K LINE Inspection

  1. Ignition "ON" & Engine "OFF" and Using a scan tool, clear the DTC.
  2. Ignition "OFF".
  3. Disconnect the battery negative cable, then disconnect the positive cable, and wait at least one minutes.
  4. Disconnect the WCS MODULE from the WCS wiring harness.
  5. Disconnect the SRSCM from the WCS wiring harness.
  6. Measure resistance between of the WCS Communication K LINE wiring connector and BCM harness connector.

    Specification  : approx. 1 Ω below

  7. Is the measured resistance within specifications?

    YES 

    NO 

    • Substitute the SRSCM main harness or WCS Module or SRSCM and check for proper operation.

      If the problem is corrected, replace SRSCM main harness WCS Module or SRSCM and then go to "VERIFICATION OF VEHICLE REPAIR " procedure and Go to "WCS RESET " procedure.

scientia non olet · About Mike's Workshop Manuals