Component Inspection

Measure the resistance between terminal 1 and 3 of Fuel Level Sensor harness connector.

(Component side) (Measure the resistance with Change the position of a float.)

Specification:

DTC P0462 FLOAT POSITION TABLE

Float Position	Sender Resistance (Ω)	Fuel Height at Tank Bottom (mm)	Fuel Tank Volume Reference only
Float Position	Sender Resistance (Ω)	Fuel Height at Tank Bottom (mm)	lit.	U.S.gal.
S/F	6.0±2	155.6±2	43.0	11.4
G/F	15.0±2	151.8±2	42.0	11.1
7/8	25.0±2	135.6±2	37.5	9.9
6/8	36.0±2	120.6±2	33.0	8.7
5/8	50.0±2	106.2±2	28.5	7.5
4/8	66.0±2	93.1±2	24.0	6.3
3/8	86.0±2	79.9±2	19.5	5.2
2/8	110.2±2	66.4±2	15.0	4.0
1/8	142.0±2	51.8±2	10.5	2.8
W/G	170.0±2	34.5±2	6.6	1.7
G/E	184.0±2	29.6±2	5.0	1.3
S/E	200.0±2	25.2±2	4.0	1.1
NOTE: S/F: Sensor Full G/F: Gauge Full W/G: Warning Point G/E: Gauge End S/E: Sensor End 7/8, 6/8, 5/8, 4/8, 3/8, 2/8, 1/8: Indicator Position in cluster

Fig 1: Measuring Resistance Between Terminal 1 And 3 Of Fuel Level Sensor Harness Connector

Courtesy of HYUNDAI MOTOR CO.

Is the measured resistance within specification?
YES
- Substitute with a known-good ECM/PCM and check for proper operation. If the problem is corrected, replace ECM/PCM and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Substitute with a known-good Fuel Level Sensor and check for proper operation. If the problem is corrected, replace Fuel Level Sensor and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.