Component Inspection

Measure resistance between terminals 1 and 2 of OTS connector. (Component side)

TEMPERATURE AND RESISTANCE SPECIFICATION

Temp. (°C)	Temp. (°F)	Resistance (kΩ)	Temp. (°C)	Temp. (°F)	Resistance (kΩ)
-20	-4	16.52	40	104	1.11
0	32	6.00	60	140	0.54
20	68	2.45	80	176	0.29

Fig 1: Measuring Resistance Between Terminals 1 And 2 Of OTS Connector

Courtesy of HYUNDAI MOTOR CO.

Is sensor switching properly?
YES : --> Check for poor connection between PCM and component: backed out terminal, improper mating, broken locks or poor terminal to wire connection. Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

NO : --> Check OTS for contamination, deterioration, or damage. Substitute with a known-good OTS and check for proper operation. If the problem is corrected, replace OTS and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.