Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2008 >> Entourage GLS >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System Diagnosis (1 Of 2) >> DTC Troubleshooting Procedures >> DTC P0222 Throttle/Pedal Position Sensor/Switch "B" Circuit Low Input >> Signal Circuit Inspection

Signal Circuit Inspection

  1. Check short to ground in harness
    1. IG "OFF" and disconnect TPS connector and PCM connector.
    2. Measure resistance between terminal 6 of TPS harness connector and chassis ground.
    3. Measure resistance between terminals 6 and 5 (8) of TPS harness connector.

      Specification: Infinite

      Fig 1: Measuring Resistance Between Terminal 6 Of TPS Harness Connector And Chassis Ground
      G05322019Courtesy of HYUNDAI MOTOR CO.
    4. Is the measured resistance within specification?

      YES 

      • Go to " 2Check open in harness" as follows

      NO 

  2. Check open in harness
    1. IG "OFF" and disconnect TPS connector and PCM connector.
    2. Measure resistance between terminal 6 of TPS harness connector and terminal 57 of PCM harness connector.

      Specification: Below 1Ω

      Fig 2: Measuring Resistance Between Terminal 6 Of TPS Harness Connector And Terminal 57 Of PCM Harness Connector
      G05322020Courtesy of HYUNDAI MOTOR CO.
    3. Is the measured resistance within specification?

      YES 

      NO 

scientia non olet · About Mike's Workshop Manuals