Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2008 >> Accent GLS, Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System Diagnosis (1 Of 2) >> DTC Troubleshooting Procedures >> DTC P0106 Manifold Absolute Pressure/Barometric Pressure Circuit Range/Performance >> Monitor SCANTOOL Data

Monitor SCANTOOL Data

  1. Connect scantool to Data Link Connector(DLC).
  2. IG "ON"
  3. Select "Diagnostic Trouble Codes(DTCs)" mode, and then Press F4(DTAL) to check DTC's information from the DTCs menu
  4. Confirm that "DTC Readiness Flag" indicates "Complete". If not, drive the vehicle within conditions noted in the freeze frame data or enable conditions noted in the DTC detecting condition.
  5. Read "DTC Status" parameter.
    Fig 1: Scantool Displays & Conditions
    G00455592Courtesy of HYUNDAI MOTOR CO.
  6. Is parameter displayed "History(Not Present) fault"?
NOTE:
  • History fault : DTC occurred but has been cleared.
  • Present fault : DTC is occurring at present time.

YES  :- -> Fault is intermittent caused by poor contact in the sensor' s and/or ECM' s connector or was repaired and ECM memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "Verification, of Vehicle Repair" procedure.

NO  : - -> Go to "Terminal & Connector Inspection" procedure

scientia non olet · About Mike's Workshop Manuals