Open Or Short Check
- Ignition "ON" & Engine "OFF".
- Measure voltage between power terminal of the G sensor harness connector and chassis ground.
Specification : Approx. 5V
- Is the measured value within specifications?
YES:
- Go to "GROUND CIRCUIT INSPECTION " procedure.
NO:
- Repair open or short in power circuit between the G sensor harness connector and HECU harness connector and then, go to "VERIFICATION OF VEHICLE REPAIR " procedure.
- If there is no problem in Power circuit, Substitute with a known-good HECU and check for proper operation. If problem is corrected, replace HECU and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.