Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2007 >> Tucson SE, FWD >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transaxle System >> DTC Troubleshooting Procedure >> DTC P0732 Gear 2 Incorrect Ratio >> Monitor SCANTOOL Data

Monitor SCANTOOL Data

  1. Connect scantool to data link connector (DLC).
  2. Engine "ON".
  3. Monitor the "ENGINE SPEED, INPUT SPEED SENSOR, OUTPUT SPEED SENSOR, GEAR POSITION" parameter on the scantool.
  4. Perform the "STALL TEST" with gear position "2"

    Specification: 2000~2700 engine RPM

    Fig 1: Scan Tool Display - Shift Position
    G04811294Courtesy of HYUNDAI MOTOR CO.
scientia non olet · About Mike's Workshop Manuals