Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2007 >> Tucson SE, FWD >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transaxle System >> DTC Troubleshooting Procedure >> DTC P0708 Transaxle Range Sensor - High >> Signal Circuit Inspection

Signal Circuit Inspection

  1. Ignition "OFF".
  2. Disconnect "TRANSAXLE RANGE SWITCH" and "TCM(PCM)" connector.
  3. Measure resistance between each terminals of the sensor harness to check for Short.

    Specification: Infinite

    Fig 1: Measuring Resistance Between Terminals Of Sensor Harness To Check For Short
    G04811262Courtesy of HYUNDAI MOTOR CO.
  4. Is resistance within specifications?

    YES  : --> Go to "COMPONENT INSPECTION " procedure.

    NO  : --> Check for Open in harness. Repair as necessary and Go to "VERIFICATION OF VEHICLE REPAIR " procedure.

scientia non olet · About Mike's Workshop Manuals