Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2007 >> Tiburon SE >> Repair and Diagnosis >> Accessories & Equipment >> Anti-Theft Systems >> Immobilizer Control System >> Immobilizer Control System >> DTC 5 BCM Internal Fault Or EEPROM >> Monitor SCANTOOL Data

Monitor SCANTOOL Data

  1. Ignition "ON" & Engine "OFF".
  2. Select Diagnostic Trouble Codes (DTCs) " mode and Clear the DTC.
    Fig 1: Scantool Display - Diagnostic Trouble Codes
    G05344645Courtesy of HYUNDAI MOTOR CO.
  3. Is the DTC erased?

    YES 

    Fault is intermittent caused by poor contact in the BCM and/or the antenna coil connector or was repaired and BCM memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.

    Repair or replace as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NO 

    Go to "COMPONENT INSPECTION " procedure.

scientia non olet · About Mike's Workshop Manuals