Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2007 >> Entourage GLS >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Immobilizer Control System >> Immobilize Control System >> DTC P1692 Immobilizer Lamp Circuit Malfunction >> Component Inspection

Component Inspection

  1. Check immobilizer lamp.
  1. Ignition "OFF"
  2. Disconnect PCM (ECM).
  3. Ground terminal "C4" of immobilizer lamp.
  4. Ignition "ON" and Monitor operation of immobilizer lamp.

    Specification : immobilizer lamp "ON"

    Fig 1: Checking Immobilizer Lamp
    G05325525Courtesy of HYUNDAI MOTOR CO.
  5. Is the Immobilizer lamp "ON"?

    YES 

    Substitute with a known-good PCM (ECM) and check for proper operation.

    If the problem is corrected, replace PCM (ECM) and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NOTE: PCM (ECM) substituted for old one must be in "Virgin" or "Neutral" status and Pin code is required to Neutralize PCM (ECM) and to Register transponder key.

    Check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.

scientia non olet · About Mike's Workshop Manuals