Control Circuit Inspection

Check voltage
1. IG "OFF" and disconnect VIS connector.
2. IG "ON" and ENG "OFF"
3. Measure voltage between terminal 2 of VIS harness connector and chassis ground.
  Specification: Approx. 2.5V
4. Is the measured voltage within specification?
  YES
  - Go to "COMPONENT INSPECTION " procedure.
  NO
  - Go to " 2Check short in harness" as follows.
Check short in harness
1. IG "OFF" and disconnect VIS connector and PCM connector.
2. Measure resistance between terminal 2 of VIS harness connector and chassis ground.
3. Measure resistance between terminals 1 and 2 of VIS harness connector.
  Specification: Infinite
4. Is the measured resistance within specification?
  YES
  - Go to " 3Check open in harness" as follows.
  NO
  - Repair short in harness, and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
Check open in harness
1. IG "OFF" and disconnect VIS connector and PCM connector.
2. Measure resistance between terminal 2 of VIS harness connector and terminal 71 of PCM harness connector.
  Specification: Below 1Ω
3. Is the measured resistance within specification?
  YES
  - Go to "COMPONENT INSPECTION " procedure.
  NO
  - Repair open in harness, and go to "VERIFICATION OF VEHICLE REPAIR " procedure.