Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2007 >> Azera GLS >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System Diagnosis (2 Of 2) >> DTC Troubleshooting Procedures >> DTC P0533 A/C Refrigerant Pressure Sensor "A" Circuit High Input >> Component Inspection

Component Inspection

  1. A/C pressure sensor inspection
    1. Key "OFF" and connect the scantool.
    2. Connect the probe to A/C pressure sensor signal and select the oscilloscope in the menu.
    3. Check the waveform with acceleration and deceleration after engine start.

      SPECIFICATION: 

      PRESSURE AND VOLTAGE REFERENCE CHART

      Pressure (psi) 14.7 56.7 250 439.7 465
      Voltage (V) 0.203 0.629 2.633 4.649 4.8
      Fig 1: Identifying Signal Waveform
      G04879912
    4. Is the measured waveform of A/C pressure sensor normal?

      YES 

      • Substitute with a known - good PCM and check for proper operation. If the problem is corrected, replace PCM and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

      NO 

      • Substitute with a known - good A/C pressure sensor and check for proper operation. If the problem is corrected, replace A/C pressure sensor and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
      NOTE: There is a memory reset function on scantool that can erase optional parts automatically detected and memorized by PCM. After testing PCM on the vehicle, use this function to reuse the PCM on the others
scientia non olet · About Mike's Workshop Manuals