Power Circuit Inspection
- IG "OFF" & ENG "OFF"
- Disconnect fuel pump relay.
- IG "ON" & ENG "OFF"
- Measure voltage between harness terminal 1 (5) of chassis ground.
Specification: B+
- Is the measured voltage within specification?
YES
- Go to "CONTROL CIRCUIT INSPECTION " procedure.
NO
- Check "Fuse" between fuel pump relay and main relay is not installed or blown off
- Check "Fuse" between fuel pump relay and battery is not installed or blown off
- Especially, if battery voltage at terminal 5 is not detected, replace the Main Relay.
- Repair or replace as necessary and then, go to "VERIFICATION OF VEHICLE REPAIR " procedure.