Power Circuit Inspection
- IG "OFF" & Disconnect OCV (B1) connector.
- IG "ON" & ENG "OFF".
- Measure voltage between terminal 1 of OCV (B1) harness connector and chassis ground.
Specification: B+
- Is the measured voltage within specification?
YES
- Go to "CONTROL CIRCUIT INSPECTION " procedure.
NO
- Check fuse between Main Relay and OCV is open or not installed.
- Check open in power circuit between Main Relay and OCV power circuit.
- Repair or replace as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.