Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2006 >> Tucson GLS, FWD >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Fuel System (G6BA - GSL 2.7) >> DTC Troubleshooting Procedures >> DTC P0175 System Too Rich (Bank 2) >> Fuel System Inspection >> Notes

Fuel System Inspection: Notes

  1. Check the fuel for excessive water, alcohol, or other contaminants. Replace contaminated fuel as necessary.
  2. Disconnect the vacuum hose from the fuel pressure regulator and inspect the hose for the presence of fuel. If any fuel is present in the vacuum hose, replace the fuel pressure regulator. Go to next step.
  3. Install a fuel pressure gage.
  4. Start engine and let it idle. With the vacuum hose from the fuel pressure regulator disconnected, inspect fuel pressure.

    Specification: 330~350kPa ( 3.30~3.50 kg/cm2 , 47~50 psi)

  5. Is fuel pressure within the specification?

    YES  : --> Go to "FUEL INJECTOR INSPECTION " procedure. as below.

    NO  : --> Repair as necessary refer to inspection note as below and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NOTE:
    1. Check if fuel line pressure decreases when accelerating quickly
      • If it does, check fuel pump maximum pressure. If pressure is OK, check fuel line and filter for clogging.
    2. If pressure quickly increases, check pressure regulator.
      • If pressure quickly increases, check pressure regulator
      • If pressure gradually increases, check for clogging between fuel pump and pressure regulator. If hose is not clogged, check fuel pump maximum pressure.
    3. If fuel pressure is higher than specification: Is fuel line clogged?
      • If it is not, replace pressure regulator.
      • If it is, replace it.
scientia non olet · About Mike's Workshop Manuals