Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2006 >> Santa Fe Limited, AWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System Diagnosis (3.5L) (2 Of 2) >> DTC Troubleshooting >> DTC P0564 Cruise Control Multi-Function Input "A" Circuit >> Component Inspection

Component Inspection

  1. Ignition "OFF"
  2. Measure cruise remote control switch resistance as follows. (Component side)

    SPECIFICATION 

    TERMINALS RESISTANCE CHART

    Terminal Condition Resistance
    1 & 2 Pushing the Main SW 3.9kΩ ± 5%
    1 & 3 Pushing the Cancel SW 0Ω
    Pushing the Set/Coast SW 220Ω ± 5%
    Pushing the Resume/Accel SW 910Ω ± 5%
  3. Is resistance within the specification?

    YES:  

    • Check for poor connection between PCM and component: backed out terminal, improper mating, broken locks or poor terminal to wire connection. Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure

    NO:  

    • Substitute with a known-good cruise remote control switch and check for proper operation. If the problem is corrected, replace cruise remote control switch and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
scientia non olet · About Mike's Workshop Manuals