Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2006 >> Santa Fe Limited, AWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System Diagnosis (3.5L) (1 Of 2) >> DTC Troubleshooting >> DTC P0337 Crankshaft Position Sensor A Circuit Low Input >> Monitor Scan Tool Data

Monitor Scan Tool Data

  1. Engine "ON"
  2. Monitor "Engine Speed (RPM)" parameter on scan tool.
    NOTE: Scan Tool provides "Engine Speed (RPM)" parameter for CKPS.
    Fig 1: Scan Tool Display - CURRENT DATA
    G04931844Courtesy of HYUNDAI MOTOR CO.
  3. Does the "Engine Speed (RPM)" on scan tool coincide with "Engine Speed (RPM)" on instrument board each other?

    YES:  

    • Fault is intermittent caused by poor contact in the sensor' s and/or PCM' s connector or was repaired and PCM memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and go to "VERIFICATION VEHICLE REPAIR " procedure.

    NO:  

scientia non olet · About Mike's Workshop Manuals