Ground Circuit Inspection

Ignition "OFF".
Disconnect PCM connector.
Measure resistance between terminals 2 of the FTPS harness connector and 34 of the PCM harness connector.
Specification: Approx. 0Ω

Fig 1: Measuring Resistance Between Terminals 2 Of FTPS Connector And 34 Of PCM Connector
Courtesy of HYUNDAI MOTOR CO.
Is resistance within the specification?
Yes:
- Go to "SIGNAL CIRCUIT INSPECTION " procedure
No:
- Check for a open/short circuit. Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure