Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2006 >> Accent Automatic >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transaxle System (A4AF3) >> Automatic Transaxle System >> DTC P0716 Input Speed Sensor Rationality >> Signal Circuit Inspection

Signal Circuit Inspection

  1. Ignition "ON" & Engine "OFF".
  2. Disconnect the "INPUT SPEED SENSOR" connector.
  3. Measure voltage between terminal "1" of the INPUT SPEED SENSOR harness connector and chassis ground.

    Specification: approx. 1.45V

    Fig 1: Measuring Voltage Between Terminal 1 Of Input Speed Sensor Harness Connector & Chassis Ground
    G04802082Courtesy of HYUNDAI MOTOR CO.
  4. Is voltage within specifications?

    YES  : --> Go to "GROUND CIRCUIT INSPECTION " procedure.

    NO  : --> Check for open or short in harness. Repair as necessary and Go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    --> If signal circuit in harness is OK, Go to "Check PCM" of the "Component inspection" procedure.

scientia non olet · About Mike's Workshop Manuals