Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2005 >> XG350 Base >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System Diagnosis (2 Of 2) >> Trouble Shooting For DTC >> DTC P0630: VIN Not Programmed Or Incompatible >> Scantool Diagnostics >> Monitor Scantool Data

Monitor Scantool Data

  1. Ignition "OFF".
  2. Connect Scantool and Engine "ON".
  3. Monitor the ECM status whether it is virgin or learned.
    Fig 1: Monitoring ECM Status
    G07375554
  4. Is the ECM status Virgin?

    YES

    NO

    • Fault is intermittent caused by poor contact in Sensor's and/or PCM's connector or was repaired and PCM memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
scientia non olet · About Mike's Workshop Manuals