Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2004 >> XG350 Base >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System Diagnosis (1 Of 2) >> Trouble Shooting For DTC >> DTC P0107: Manifold Absolute Pressure Circuit Low Input >> Inspection/Repair >> Component Inspection

Component Inspection

  1. Check performance test.
    1. Ignition "OFF".
    2. Remove the MAP sensor and connect MAP sensor connector.
    3. Ignition "ON" & Engine "OFF".
    4. Using s hand-held vacuum pump, apply vacuum and measure the "MAP SENSOR" parameter on scantool.
      1. Specification:
        MAP SENSOR VOLTAGE SPECIFICATIONS

        Applied Vacuum Output Voltage
        10 kPa (100 mbar, 1.45 psi) 0.06V
        5 kPa (150 mbar, 2.18 psi) 0.25V
        40 kPa (400 mbar, 5.8 psi) 1.3V
        80 kPa (800 mbar, 11.6 psi) 3V
        120 kPa (1200 mbar, 17.4 psi) 4.8V
    5. Is the parameter displayed within specification?

      YES

      • Go to " 2 Check PCM" as below.

      NO

      • Substitute with a known - good MAP and check for proper operation.

        If the problem is corrected, replace MAP and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

  2. Check PCM
    1. Ignition "OFF" & Engine "OFF"
    2. Connect scantool and Ignition "ON"
    3. Select simulation function on scantool.
    4. Simulate voltage at terminal 1 of MAP sensor signal connector.
      Fig 1: Display - MAP Sensor Voltage Simulation
      G07374060
    5. Does the signal value of MAP sensor changes according to simulation voltage?

      YES

      • Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration damage. Repair or replace as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

      NO

      • Substitute with a known - good PCM and check for proper operation.

        If the problem is corrected, replace PCM and go to "VERIFICATION OF VEHICLE REPAIR " procedure.