Inspection Procedure

1. Connect the hi-scan (pro) to data link connector.
2. Turn the ignition switch to ON and verify the DTC "P1801" is displayed.
3. Erase the DTC "P1801" with the hi-scan (pro) and then monitor again.

Is the same code displayed? 

1. Yes: Go to next step.
2. No: Problem is intermittent and engine control module memory was not cleared.

1. The key teaching is done after replacing a defective ECM or for providing of additional keys to the vehicle owner.
2. Connect the hi-scan (pro) to data link connector.
3. Turn the ignition switch to ON and select "TEACHING" mode of immobilizer system on the hi-scan (pro).
4. Input the pin code which consists of 6 digits.
   NOTE: Because the pin code is security code, contact authorized HMC service staff to know the pin code.
5. If incorrect pin code is inputted for 3 consecutive times, ECM should disallow key teaching function for 1 hours.
6. If the data is correct, the key teaching is completed.

Is the key taught completely? 

1. Yes: Go to next step.
2. No: Check for these problems:
   • Storage of invalid data in transponder.
   • Different kind of transponder.
   • Omitted transponder in the key.

1. Connect the hi-scan (pro) to data link connector.
2. Turn the ignition switch to ON and verify the DTC "P1801" is displayed.

Is the same code displayed? 

1. Yes: Go to next step.

Replace the key set assembly and key teaching must be done.